12/18/2023 0 Comments Update prusa slicer![]() If your original firmware version is lower than V2.1.11_20221111, after the firmware update, you need to run all calibration procedures again from Calibration section on the screen.Insert the USB flash drive into J1 and select Settings - Local Upgrade - USB - select firmware file on the screen to start the update.Download the high-speed firmware version and save it to a USB flash drive.Firmware Upgrade Method - For current beta version only Inaccurate printing time calculation shown on the screen. ![]() Accidentally trigger the detection of filament runout/clogging by mistake.The calibration data is lost after the update.Optimize print settings of Offset Calibration Check model and Vibration Compensation Check model.(Need to use the latest release of SnapmakerJ1CuraPlugin.) Add support for SnapmakerJ1CuraPlugin, enabling file transfer via WiFi.Add three G-code files - PLA in Local files in the screen (for getting started).Update two G-code files - PLA in Local files in the screen (3DBenchy, Shark).Fixed stall protection failing risks occur when there’s a glass build plate on the heated bed.Fixed a bug when resuming from a paused print.Improved calibration accuracy for bed leveling and XY calibration.Fixed XZ drift issue for dual extruder printing.Fixed internal print file(test_3dbenchy) estimated time.Improved frequency value in Vibration Compensation Chooing Area page.Fixed a bug that adjusting Live Z Offset when homing position cause unexpected movement.Optimized PID value for heated bed to prevent ripples on print.Fixed a bug that stopped printing job when execuing heating G-code causes unexpected movement. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |